Front-And-Rear Mounting The Ja2500 Appliance Recessed In A; Rack - Juniper Junos Space JA2500 Quick Start Manual

JA2500 Junos Space Appliance Quick Start
8
Secure the rear-mount rail brackets to your equipment rack with two rack-mount
3.
screws each.
Insert locking screws on the sides of the rear-mount brackets to secure the front and
4.
rear mounting brackets in place.
Figure 3: Front-and-Rear Mounting Flush to a Rack
Verify that the mounting screws on one side of the rack are aligned with the mounting
5.
screws on the opposite side and that the appliance is level.
Front-and-Rear Mounting the JA2500 Appliance Recessed in a Rack
The recessed position allows network and console cables to be routed through the sides
of the equipment rack and through the holes of the recessed front rails on either side of
the unit. This enables easy cable routing on the racks with limited cable management.
To mount the JA2500 appliance front and rear recessed in a rack, do the following:
Remove the rear screws on each side of the appliance's front rails and the two small
1.
screws toward the front of the chassis.
Loosen the side-rail screws of the chassis and slide the front rails of the system
2.
backward, as far as they will move.
Tighten the side-rail screws.
3.
Insert the two small screws in the recessed holes on the front rails and tighten.
4.
Slide the rear-mount rail brackets into the backs of the front rails on either side of the
5.
chassis and align with your rear equipment rack posts. Secure the rear-mount rail
brackets to your equipment rack with two rack mount screws each, as shown in
Figure 4 on page 9.
Copyright © 2018, Juniper Networks, Inc.