Yaesu FTM-300DR Instruction Manual page 54

WEATHER:
YAESU:
OTHER PACKET: Only RAW NMEA data stations, status stations and non-
CALL RINGER:
RANGE RINGER: Only information of stations deemed as nearby stations
1200 bps:
9600 bps:
Tips
• [F(SETUP)] → [SORT] in the function menu of the station list to sort the station list.
• When a new beacon is received after sorting, it will be added to the top of the list without being sorted.
The sorting order will be restored to the initial setting when the radio is turned OFF.
y 30 VOICE ALERT
Voice alert function setting.
Setting Item: VOICE ALERT: NORMAL / TONE SQL / DCS / RX-TSQL / RX-DCS
TONE SQL:
DCS:
Default: VOICE ALERT: TIME
TONE SQL:
DCS:
Explanation:
This is an audio notification function that will announce the presence of other stations
which can communicate via voice communications.
VOICE ALERT: Set the operation of the voice alert function.
NORMAL:
TONE SQL: A tone squelch will be used for sending and receiving voice
DCS:
Only meteorological stations will be displayed.
Only stations which are using Yaesu wireless transceivers
will be displayed.
APRS packet information that cannot be analyzed are
displayed. Set "OTHER" to ON under [APRS] → [2 APRS
FILTER] in the set-up menu to display non-APRS packets
that cannot be analyzed.
Only information of callsign ringer stations set under [APRS]
→ [8 APRS RINGER (CS)] in the set-up menu will be
displayed.
according to "RANGE RINGER" settings that are set under
[APRS] → [7 APRS RINGER] in the set-up menu will be
displayed.
Only stations received using 1200 bps packets will be
displayed.
Only stations received using 9600 bps packets will be
displayed.
88.5 Hz to 254.1 Hz
023 to 754
ALL
023
The voice alert function will be turned off.
signals. A tone signal will also be appended when sending
APRS data.
DCS will be used in sending and receiving voice signals.
The DCS code will also be appended when sending APRS
data.
53