Yaesu FTM-300DR Instruction Manual page 44

y 9 APRS TXDELAY
Set the data sending delay time.
Setting item: 100 ms / 150 ms / 200 ms / 250 ms / 300 ms / 400 ms / 500 ms / 750 ms
/ 1000ms
Default: 250 ms
Explanation:
The preamble (data transmission delay time),
shown right, for when transmitting APRS data
can be set.
y 10 APRS UNITS
Unit setting for APRS display.
Setting item: POSITION: dd°MM.MM' / dd°MM'SS"
DISTANCE: km / mile
SPEED: km/h / mph / knot
ALTITUDE: m / ft
BARO:
TEMP:
RAIN:
WIND:
Default: Depends on the transceiver version.
Explanation:
Set the measurement unit for Latitude/Longitude (POSITION), DISTANCE, SPEED,
ALTITUDE, Barometric pressure (BARO), Temperature (TEMP), Precipitation (RAIN),
and Wind Speed (WIND).
POSITION: Unit display of minute of Longitude/Latitude (dd°MM'SS" can be changed.
MM' is displayed in 1/100 minute and SS" in seconds.
DISTANCE: Unit can be set to [km] or [mile].
SPEED: Unit can be set to [km], [mile] or [knot].
ALTITUDE: Unit can be set to [m] or [feet].
BARO: Unit can be set to [hPa], [mb], [mmHg], [hPa] or [inHg].
TEMP: Unit can be set to [°C] or [°F].
RAIN: Unit can be set to [mm] or [inch].
WIND: Unit can be set to [m/s], [mph] or [knot].
hPa / mb / mmHg / inHg
°C / °F
mm / inch
m/s / mph / knot
43
APRS beacon transmission content
Start Transmission
Preamble
(data transmission delay time)
(Default: 300ms)
Hours
End Transmission
APRS Data