Yaesu FTM-300DR Instruction Manual page 43

CALL RINGER:
RANGE RINGER: OFF
MSG VOICE:
Explanation:
Set the bell sound for transmit/receive of APRS beacons and messages and the conditions
for when it rings.
• TX BEACON:
• TX MESSAGE:
• RX BEACON:
• RX MESSAGE:
• MY PACKET:
• CALL RINGER:
• RANGE RINGER: A special bell will ring when a beacon located close to your own
• MSG VOICE:
y 8 APRS RINGER (CS)
Callsign setting for CALL RINGER
Setting Items:
-NN
: Callsign (a maximum of 6 characters)
NN: SSID (a number between one and 15 or nil)
Explanation:
Turn "CALL RINGER" under [APRS] → [7 APRS RINGER] in the set-up menu to ON
to set the callsign of the station which will ring the special bell. A maximum of up to 8
callsigns can be set.
OFF
OFF
This sets the bell ring when your own station is sending a beacon.
When set to ON, a bell will ring prior to the transmission.
This sets the bell ring when your own station is sending
a message. When set to ON, a bell will ring prior to the
transmission.
This sets the bell ring when a beacon is received from another
station. When set to ON, a bell will ring when a beacon is
received.
This sets the bell ring when a message is received from another
station. When set to ON, a bell will ring when a message is
received.
This sets the bell ring when your own station transmit beacon
(relayed signal) is received.
A bell will ring when a beacon from a station whose callsign is
set using [APRS] → [8 APRS RINGER (CS)] in the set-up menu
is received.
station is received. When distance is selected, a special bell
will ring when a beacon from a station closer than the distance
set is received. When OFF is selected, the distance will not be
determined.
Read out the message content. When set to ON, the message
contents (callsign and main text) are read out when a message
is received (the optional voice guide unit FVS-2 is required).
42