Yaesu FTM-300DR Instruction Manual page 49

y 20 DIGI PATH FULL 2
Setting the digipeater route addresses.
Setting item: ADDRESS 1
ADDRESS 2
ADDRESS 3
ADDRESS 4
ADDRESS 5
ADDRESS 6
ADDRESS 7
ADDRESS 8
Default: –– –– –– ––
Explanation: Enter specific address information (callsign and alias) when "FULL 2" is
selected in [APRS] → [14 DIGI PATH] in the setup menu.
A maximum of up to 8 addresses can be specified.
y 21 CALLSIGN (APRS)
Specify the CALLSIGN of your station.
Explanation:
Register the CALLSIGN of your station which is needed for APRS communication.
APRS data cannot be transmitted if a CALLSIGN for your station is not registered.
Be sure to register a CALLSIGN.
When a CALLSIGN is registered to your station, it is displayed on the LCD when the
power of this transceiver is turned on.
Register a CALLSIGN as shown below.
 – NN
: CALLSIGN (Up to 6 characters)
NN: Number (a number between 1 to 15, or no SSID.)
Entering [-9] after the CALLSIGN is recommended in standard mobile use.
48