Yaesu FTM-300DR Instruction Manual page 47

y 14 DIGI PATH
Setting the digipeater route.
Setting item: OFF / WIDE1-1 / WIDE1-1,WIDE2-1 / PATH 1 / PATH 2 / PATH 3 / PATH 4
/ FULL 1 / FULL 2
Default: WIDE1-1
Explanation:
A station that relays packets, such as beacons, is called a digipeater.
Select a CALLSIGN or ALIAS of the digipeater you would like to use.
In this transceiver, [WIDE1-1] (setting for 1 relay station) and [WIDE1-1/WIDE2-1] (setting
for 2 relay stations) is the default.
In [WIDE1-1, WIDE2-1], a transmission is relayed to the first digipeater station specified
as WIDE1-1, then to the second digipeater station specified as WIDE2-1.
In the USA, digipeater stations used by APRS are customarily operated using *New-
Paradigm.
The initial values set to this transceiver are premised for digipeater stations operating with
New- Paradigm, because most digipeater stations support this method.
In order to use other relay methods, select one of PATH 1 to PATH 4, FULL 1 or PATH 2,
and enter the CALLSIGN or ALIAS.
* For information on the New-Paradigm method, refer to the following website for details.
http://aprs.org/fix14439.html
y 15 DIGI PATH 1
Setting the digipeater route addresses.
Setting item: ADDRESS 1
ADDRESS 2
Default: –– ––– – ––
Explanation: Enter specific address information (callsign and alias) when "PATH 1" is
selected in [APRS] → [14 DIGI PATH] in the setup menu.
A maximum of up to 2 addresses can be specified.
y 16 DIGI PATH 2
Setting the digipeater route addresses.
Setting item: ADDRESS 1
ADDRESS 2
Default: –– ––– – ––
Explanation: Enter specific address information (callsign and alias) when "PATH 2" is
selected in [APRS] → [14 DIGI PATH] in the setup menu.
A maximum of up to 2 addresses can be specified.
46