Mitsubishi Electric Melservo HF-KN Series Instruction Manual page 47

5. WIRING OPTION
(4) MR-J3JSCBL03M-_-L
The servo amplifier and the servo motor cannot be connected by these cables alone. The servo motor-
side encoder cable (MR-J3ENSCBL_M-_) is required.
(a) Connection of servo amplifier and servo motor
Cable model
MR-J3JSCBL03M-A1-L Receptacle: CM10-CR10P-M
(DDK)
Applicable wire size: AWG 20 or less
MR-J3JSCBL03M-A2-L
Note. Do not connect anything to the pins shown as
Cable model Cable length
MR-J3JSCBL03M-A1-L
MR-J3JSCBL03M-A2-L
Servo amplifier
CN2
Note. For details of this cable, refer to (5) in this section.
1) Junction connector
3 2 1
MRR MR
CONT
7 6 5
LG
10 9 8
P5
SHD
View seen from wiring side. (Note)
.
IP rating Bending life
0.3 m IP65 Standard
(Note)
MR-J3ENSCBL_M-_
Connector: 2174053-1
Crimping tool for ground clip: 1596970-1
Crimping tool for receptacle contact: 1596847-1
(TE Connectivity)
4
Note. Do not connect anything to the pins shown as
5 - 12
Application
Use in combination with load-side lead
for HF-KN servo motor MR-
J3ENSCBL_M-_.
Use in combination with opposite to
load-side lead for HF-KN servo motor
MR-J3ENSCBL_M-_.
MR-J3JSCBL03M-A1-L
1)
or
MR-J3JSCBL03M-A2-L
1)
2) Encoder-side connector
9
SHD
7 8
5 MR 6 LG
3 P5 4
MRR
1 2
CONT
View seen from wiring side. (Note)
.
2)
Servo motor
HF-KN
2)
Servo motor
HF-KN