Step 3: Make The Port Settings For The Software Rip - Roland SF-200 Setup Manual

3.
Set the gateway address.
A
Press [ ].
The screen shown below appears.
NETWORK
GATEWAY ADDR.
B
Press [ ] twice to display the screen shown below.
GATEWAY ADDR.
000.000.000.000
C
Press [ ] or [ ] to select the address number.
D
Press [ ].
E
C
Repeat steps
For the value to enter for your gateway address, consult your network administrator. Here,
"255.255.255.255" is entered by way of example.
GATEWAY ADDR.
255.255.255.255
F
When you have finished making the setting, press [ENTER].
G
Press [ ].
The screen shown below appears again.
NETWORK
GATEWAY ADDR.

Step 3: Make the Port Settings for the Software RIP

• Install the software RIP and set it up. For the print destination, use the IP address set on the printer. For
information about how to make the settings, refer to the documentation for the software RIP.
• You can check whether the connection to the network has been made by using the printing-test feature of
the software RIP. For information about how to carry out a printing test, refer to the documentation for the
software RIP.
D
and to set the gateway address (255.255.255.255).
Connecting to the Computer
2.Installation
43