Equalizer (Eq); Adjusting The Tone Of A Specific Part - Part Eq - Yamaha MU128 Owner's Manual

Equalizer (EQ)

Equalizer (EQ)
Equalizer (EQ)
The MU128 features an extensive set of equalization controls that give you
comprehensive control over the tone quality — both of individual Parts and
over the entire instrument sound.
In this section, you'll learn how to:
Use the Part EQ edit parameters to adjust the tone of a specific Part.
Use the Multi EQ to adjust the overall tone of the MU128.
Adjusting the Tone of a Specific Part — Part EQ
The Part EQ parameters give you two-band (low and high frequencies) con-
trol over the sound of individual Parts. These can be used in both the Multi
mode and the Performance mode.
NOTE
When a Drum Part is selected, the EQ menu is not available. However, the same EQ
parameters can be adjusted for each individual drum sound in the "DRUM" menu.
(See page 129.)
Operation
1 Select the desired Part.
From the Multi mode Single Part display, use the [PART -/+]
buttons to select the desired Part (excepting Drum Parts).
2 Call up the EQ parameters.
Press the [EDIT] button, then select "EQ" (with the [SELECT </
>] buttons) and press the [ENTER] button.
3 Select the general frequency range — low or high.
In this example, we'll boost the bass of the Part, so select "Low
Freq" (Low Frequency) with the [SELECT </>] buttons.
92
MU128 Guided Tour