Rear Panel; Ground Screw; Network] Connector; Ac In] Connector - Yamaha SP2060 Owner's Manual

The Controls and Connectors

Rear Panel

& *
& Ground Screw
For maximum safety be sure to securely connect the SP2060
ground screw to an earth connection.
The supplied power cable has a three-prong plug that will
ground the unit when plugged into an appropriately ground-
ed three-prong type AC mains outlet. If the AC outlet is not
grounded, be sure to ground the unit by using this ground
screw.
Correct grounding will effectively eliminate hum noise and
interference.

* [AC IN] Connector

Connect to the AC mains using the supplied AC power cord.
First connect the power cord to the SP2060, then insert the
power cord plug into an AC outlet.
22
SP2060 Owner's Manual
( º
DIGITAL
INPUT
6
AES/EBU

( [NETWORK] Connector

This is a 100Base-TX/10Base-T Ethernet connector for con-
nection to a computer or other device in the network.
N OTE
• Use a CAT5 STP (Shielded Twisted Pair) cable for this
• The maximum length of a cable between a switching hub and
º [DIGITAL INPUT] Connector (AES/EBU)
Connect an output of an AES/EBU (digital signal) compat-
ible device to this XLR-3-31 connector.
¡ [OUTPUT] Connectors
These XLR-3-32 balanced connectors output six channel an-
alog audio signals. Connect them to the inputs on amplifiers.
™ [INPUT] Connectors
These XLR-3-31 balanced connectors input two channel an-
alog audio signals.
¡
OUTPUT
5 4 3 2 1
connection to prevent electromagnetic interference. Since the
SP2060 supports Auto MDI/MDI-X, it will automatically
detect whether the connected cable is of the straight type or
crossover type, and will configure itself to create the optimal
connection. Therefore, you can use either a straight or
crossover cable.
the SP2060 is 100 meters. Due to the quality of cables and
switching hub performance, however, proper operation at the
maximum length cannot be guaranteed in some cases.
™