Advertisement
= REAR PANEL
@ INPUT BALANCE control
Balances the left and right effect sound. Normally set
to the center position.
@ INPUT jacks
Inputs the signal from the control amplifier, integrated
amplifier or receiver.
@® MONO OUT jacks (FULL BAND, LOW PASS
fc: 200 Hz)
Outputs the left and right mix (MONO) signal. Use
these jacks when the left and right speakers are too
separated or the low frequencies are unsatisfied.
è FULL BAND:
Outputs the full range signal.
@ LOW PASS: Outputs the low frequency signal
below 200 Hz.
@ FRONT MIX switch
Used to mix the source signal with the front effect
Signal sent to the main speakers. When the switch is
set to "ON 4ch", both signals are mixed, and when it
is set to "OFF 6ch", they are output independently.
@ When used in 4-channel system (with 4 speakers),
set this switch to the "ON 4ch" position. The
source sound is mixed with the front effect sound
and output from the main speakers.
@® MAIN LEVEL switch
@ MAIN jacks
These jacks output the signal to the amplifier or
receiver which drives the main speakers.
@D TAPE PB jacks
These jacks input the signal output from the tape
deck.
@ REC OUT jacks
@ AC OUTLET (UNSWITCHED)
This supplies the AC power to the equipment
DSP
23
f: HAIE I
f
f
DISCO
PAVILON
WHSELOFT
STADIUM
pLEMEHONC
ECHOROOM __APTOHOHANGEE $
i L TURN
R TLAN
F-RA
L-R
PRESENCE
=]
<=
cS
SUR
D-
28
@)-
-®
DO [eccey surni) ISITA
YAMAHA
REMOTE CONTROL,
i
TRANSMITTE
RS-DS
:
14
Advertisement
