Limiter; Scene; About A Scene - Yamaha SP2060 Owner's Manual

Panel Operation
5.
To confirm the selection, press the [YES] key.
The library is recalled and the unit returns to the Library
List display.
LIBRARY LIST
IF2112/95
To cancel the recall operation, press the [NO] key, in-
stead of the [YES] key. The unit returns to the Library
List display.
H IN T
You can use the library data for speaker processor components for
DME64N/24N that you have created using DME Designer.

LIMITER

You can set up the Output channel limiter.
The Limiter precludes signal levels higher than a specified
threshold to avoid speaker damage from excess output level.
Parameter Range
THRESHOLD –54 through 0dB
FAST
MID
ATTACK SLOW
MANUAL (0–
120.0ms)
FAST
MID
SLOW
MANUAL
RELEASE
44.1kHz: 6ms–46s,
48kHz: 5ms–42.3s,
88.2kHz: 3ms–23s,
96kHz: 3ms–21.1s
NOT E
• You can set the attack time only when "Manual" is selected for
the Attack parameter.
• You can set the release time only when "Manual" is selected for
the Release parameter.
1.
2.
3.
4.
Function
5.
Sets the threshold
value.
Sets the attack time.
Sets the release time.
If you select Fast, 6.
Mid, or Slow, the unit
automatically sets the
optimum value based
on the maximum
wave length of audio

SCENE

input to the Limiter.

About a scene

The SP2060 enables you to store various parameter settings
as part of scene, and recall them via the front panel or re-
motely from DME Designer.
You can store the following settings in a scene:
Press the [LIMITER] key to select the Limiter
display.
OUT 1
ON/OFF =
Press the [SEL] key for the target channel.
The [SEL] key LED of the selected channel lights up,
and the corresponding channel name is displayed.
OUT 4
ON/OFF =
Press the [LIMITER], [BACK] or [NEXT] key to
display the On/Off parameter.
Press the [▲INC] key to set the On/Off
parameter to On to apply the Limiter to the
signal. Press the [▼DEC] key to set the On/
Off parameter to Off to cancel the Limiter.
Press the [NEXT]/[BACK] keys to select a
parameter to edit.
OUT 4
THRESHOLD= -54dB
Press the [▲INC]/[▼DEC] keys to set the
parameter value.
• Configuration
• Routing
• Parameter sets of all components
• Scene titles
• Scene protection status
• INPUT A/B LINK
• The title of the library most recently recalled
H IN T
You can protect a scene to forbid overwriting.
ON
ON
SP2060 Owner's Manual
29