Display Messages; Warning And Error Messages - Yamaha SP2060 Owner's Manual

References

Display Messages

Warning and error messages

Message
Duplicate IP Adr.
Illegal MAC Adr.
Invalid IP Adr.
Network Error
No MAC Adr.
No Battery
Critical Battery
Low Battery
Recovering
Scene Recall Err
Saving Failed
Param Access Err
Param Set Err
W.Clk Unlocked
DevGrp Sync Err
System Error
* Do NOT turn off the power to the SP2060 while the unit displays the message "DO NOT TURN OFF!" at the bottom of the display.
44
SP2060 Owner's Manual
Meaning
Duplicate IP addresses.
An illegal MAC address has been encountered.
The IP address is not set properly.
A cable is disconnected, the power to the
connected switching hub or router is turned off, or a
cable is not in proper condition.
MAC address not specified.
The internal battery is completely discharged or not
installed.
The internal battery is almost discharged. Your data
may be lost.
The backup battery voltage is low.
A program update attempt has failed, and the
previous program is currently being restored.
A scene recall attempt has failed.
A save operation has failed.
Current setting cannot be displayed.
Current setting cannot be changed.
A usable word clock signal is not being received or
cannot be detected.
The device group configuration set via DME
Designer does not match the real configuration.
A system error has occurred.
Action
Change the IP addresses so that there are no duplicates.
This could be due to a hardware malfunction. Refer this
problem to a contact a Yamaha dealer.
Set an appropriate network IP address.
Connect the cables properly, and make sure that the hub
and/or router are operating correctly.
This could be due to a hardware malfunction. Refer this
problem to a Yamaha dealer.
If you turn off the power to the unit, the current settings will
be lost and reset to the default values. Stop operating the
unit, and contact a Yamaha dealer for battery replacement.
If you turn off the power to the unit, the current settings may
be lost and reset to the default values. Stop operating the
unit, and contact a Yamaha dealer for battery replacement.
This does not affect the operation of the unit. However, if you
continue using the unit, the settings may be lost and reset to
the default values. Contact a Yamaha dealer for battery
replacement at your earliest convenience.
Do NOT turn power off while the unit is displaying this
message. If the update attempt repeatedly fails, there may
be a hardware malfunction. Refer this problem to a Yamaha
dealer.
Recall the scene again.
If the problem persists, contact a Yamaha dealer.
This could be due to a hardware malfunction. Refer this
problem to a Yamaha dealer.
Save the current setting by using DME Designer, then
initialize the unit. If the problem persists, contact a Yamaha
dealer.
Recheck all word clock connections and internal
parameters.
Use DME Designer to go off-line, create a configuration that
correctly matches the actual configuration, and then go
back on-line to synchronize the configuration.
Save the current setting by using DME Designer, then
initialize the unit. If the problem persists, contact a Yamaha
dealer.