Routing; Input Routing; Output Routing - Yamaha SP2060 Owner's Manual

Panel Operation

ROUTING

Input routing

You can select either analog or digital input signals. This se-
lection links to the word clock master setting. You can also
route the left channel of an input signal received at the [IN-
PUT A] or [DIGITAL IN] connector to both Input chan-
nels A and B.
Option
ANA A/B
ANA A/A
DIG L/R
DIG L/L
HINT
You can check the word clock status on the Utility display. See
page 34.
1.
Press the [ROUTING] key to select the
Routing display.
2.
Press the [▲INC]/[▼DEC] keys to select an
input signal source.
NO T E
Signals are muted while they are switched between analog and
digital to avoid noise.
26
SP2060 Owner's Manual
Word Clock
Input Signal Selection
Master
A signal at the [INPUT A]
connector is routed to
channel A, and a signal at
the [INPUT B] connector
Internal clock:
to channel B.
96kHz
A signal at the [INPUT A]
connector is routed to
channels A and B.
A left channel signal is
routed to channel A, and
a right channel signal to
Incoming AES/
channel B.
EBU signal
A left channel signal is
routed to channels A and
B.
INPUT SELECT
SOURCE = ANA A/B
INPUT SELECT
SOURCE = ANA A/A

Output routing

You can route Input channel A, B, and SUM signals to the
Crossover input.
The following three channels are available:
• IN A
• IN SUM
• IN B
1.
Press the [ROUTING] key to select the
Routing display.
OUT 2
SOURCE = IN A
2.
Press the [SEL] key for the target Output
channel.
The [SEL] key LED for the selected channel lights up.
The [SEL] key LED for each channel that shares the
same component flashes. The selected channel name ap-
pears on the display.
OUT 4
SOURCE = IN A
3.
Press the [▲INC]/[▼DEC] keys to select an
input source to be routed to the Crossover.
OUT 4
SOURCE = IN SUM