Inner-Side View Of - Brother GTX pro Instruction Manual

2-4. Inner-side view of front cover
Before opening the front cover, be sure to stop all operations, then house the platen in place, and finally turn off the
power.
To open the front cover, raise it while holding the center grip and open it until it is oriented almost vertically.
<IMPORTANT>

Be sure to press the power button to turn off the power before opening the front cover.
If you open the front cover while the power is on, no cleaning will be performed at the end of the print job, which is intended to
keep the print heads in good condition.
12
11
10
7
No. Name
1 Print head (front: on the color side)
2 Print head (rear: on the white side)
3 Carriage guide shaft
4 Maintenance unit
5 Cap (rear: on the white side)
6 Wiper cleaner (rear: on the white side)
7 Wiper (for CMYK and white)
8 Flushing foam
9 Flushing receiver
10 Wiper cleaner (front: on the color side)
11 Cap (front: on the color side)
12 Carriage fixing pin
5
6
7
4
8
9
9 8
It ejects the color ink.
It ejects the white ink.
This shaft supports the carriage.
In order to keep good printing quality, this unit performs maintenance
functions to the print heads on a regular basis. (Example: Auto-Cleaning
Function)
It protects the surface of heads on the white side, and sucks ink during
head cleaning.
It removes waste ink attached to the wiper surface.
It wipes away ink from the head surface.
To keep good printing quality the foam absorbs the ink-jet droplets ejected
from the print head.
Set the flushing foam.
It removes waste ink attached to the wiper surface.
It protects the surface of heads on the color side, and sucks ink during
head cleaning.
To prevent drying of print heads in an emergency such as a blackout, it
fixes the carriage to the cap position of the maintenance unit.
27
Name and function of each component
1
3
Function
2
X0309