Brother GTX pro Instruction Manual page 127

For coating with a spray (commercial product: preferably of an electrically-operated type)
(1) Fill a spray with the diluted pretreatment.
<TIPS>

Please use a spray (preferably of an electrically-operated type) that can emit fine spray.
(2) Put a T-shirt flatly on a flat surface or lean it back against wall, and apply the pretreatment evenly onto it.
<CAUTION>

Fully take care of the air ventilation when you work on operation that generates mist such as spray application.

Be sure to wear a pair of plastic gloves, a mask and protective glasses (or goggles) designed to shield against liquid splash
during the work operation.

For information on handling of the pretreatment, see the Material Safety Data Sheet issued by us.
http://sds.brother.co.jp/sdsapp/index.html
<IMPORTANT>

If you are using an electric spray to apply the pretreatment, perform the work at a place as far as possible from the printer.
Otherwise, it may cause failure of print heads.
<TIPS>

Note that pretreatment will not soak into the back (reverse) side of a T-shirt if you put an intermediate plate in the T-shirt.
Remove the intermediate plate from the T-shirt before the pressing stage.

When you are still unaccustomed to the spray coating, perform it while measuring the amount of coating by means of a
weighing instrument.
T-shirt
Pretreatment
Spray
127
Basic printing procedures
Spray
X0083
X0084