Replacing The Wiper - Brother GTX pro Instruction Manual

9-2-7. Replacing the Wiper

Replace the wiper with a new one if it is damaged or deformed.
(1) Have the supplied gloves and wiper ready.
From the menu, select [Maintenance] > [Maintenance Part Clean/Replace], and press
(2)
<IMPORTANT>

If any other error or message is displayed on the operation panel or warning message window, follow the message to solve
the problem, then perform the cleaning.
<TIPS>

Pressing
(3) Follow the on-screen message and turn off the power.
<IMPORTANT>

Please complete the task within 15 minutes, in order to prevent the print heads from drying up.

If the task takes more than 15 minutes to complete, after attaching the flushing receiver, wiper cleaner, and wiper, close the
front cover and turn on the power, and then select [Maintenance Part Clean/Replace] again to restart the task. Then, the
head cleaning will be performed to prevent any ink from drying up.
(4) Open the front cover.
(5) Raise the wiper cleaner and move it to its upright position, and remove it by moving it upward.
<IMPORTANT>

Removed wiper cleaner should be placed with the cleaner side facing up.
<NOTE>

For a proper work operation, be sure to wear the printer-provided gloves.
causes the platen to start moving. Do not put anything around the platen.
Wiper cleaner
303
Troubleshooting
.
Front cover
X0325