Replacing The Flushing Foam - Brother GTX pro Instruction Manual

7-1-5. Replacing the flushing foam

When a warning message appears on the operation panel screen or in the warning message window, replace the
specified flushing foam with a new one.
<TIPS>

When you replace the flushing foam, check the staining state inside the printer. If parts inside the printer (carriage guide shaft,
roller guide, and carriage roller) are stained, perform cleaning.☞"7-1-6. Cleaning the internal area of printer >>P.192"
(1) Make the clean stick R, gloves and flushing foam, which come standard with the printer, available for use.
<TIPS>

For this cleaning, you can use an already-used dirty clean stick R.
(2) From the menu, select [Maintenance] > [Maintenance Part Clean/Replace], and press
(3) Select [Part with Error/Warning] and press
<IMPORTANT>

If any other error or message is displayed on the operation panel or warning message window, follow the message to solve
the problem, then perform the cleaning.
<TIPS>

Pressing
(4) Follow the on-screen message and turn off the power.
<IMPORTANT>

Please complete the task within 15 minutes, in order to prevent the print heads from drying up.

If the task takes more than 15 minutes to complete, after attaching the flushing receiver, close the front cover and turn on
the power, and then select [Maintenance Part Clean/Replace] again to restart the task. Then, the head cleaning will be
performed to prevent any ink from drying up.
Open the front cover.
(5)
Precautions to keep good printing quality/use printer over the long term
causes the platen to start moving. Do not put anything around the platen.
.
189
.