Brother GTX pro Instruction Manual page 252

Probable Cause
Is platen feed adjusted?
Is the [White High Speed Print]
check box of the print data turned
on?
Isn't the temperature low?
Isn't the [Low Temperature Mode]
set to [Disable]?
Blurring is observed (when printed with [Color Ink Only])
Probable Cause
Isn't the amount of ink excessive
against the print media?
Blurring is observed (when printed with [Color+White Ink])
Probable Cause
Is the [Highlight:] of [White Ink
Settings:] too high?
Remedy
Perform the platen feed adjustment. It is likely that
the setup value is incorrectly set after replacing a
print head or the platen with a new one.
Turn off the [White High Speed Print] check box to
create the print data.
Change the wiping frequency setting.
Change the setting to [Enable (Normal)].
Remedy
Print the ink volume and check the blurring, and select
appropriate set value for [Ink Volume:].
Remedy
Print the highlight check pattern to check the blurring,
and select appropriate set value for [Highlight:].
By turning ON the [White/Color Pause] or [Color
Multiple Pass Printing] checkbox, extend time before
the color ink settles onto the white ink, to prevent
blurring. Try this method to eliminate blurring without
weakening the highlight.
252
Troubleshooting
Reference
"7-4-4. Platen-rolling
adjustment >>P.219"
"5-4-4. Set up the white
ink >>P.94"
"8-15. Wiping frequency
settings >>P.237"
"8-11. Print Operation
Settings Under Low
Temperature >>P.234"
Reference
"5-5-5. Adjust the ink
volume >>P.109"
"5-4-7. Set up the color ink
>>P.99"
Reference
"5-5-6. Print out
highlight check
pattern/mask check
pattern >>P.110"
"5-4-4. Set up the white
ink >>P.94"
"5-4-8. Set up the white
ink >>P.100"
"5-4-6. Specify whether or
not to perform Multiple
Pass Printing >>P.98"
of