Change History - Siemens SINAMICS G120 CU230P-2 HVAC Operating Instructions Manual

Change history

Important changes with respect to the manual Edition 07/2010
New functions in firmware V4.4
Predefined settings for the converter interfaces
Two- and three-wire control via terminal block
Unit changeover
Expanded options for controlling DC braking
Automatic restart expanded by a new mode
Trace via STARTER
Revised descriptions
The description of the PM240-2 and PM250-2 Power
Modules has been removed. It is expected that this Power
Module will be released with firmware V4.5.
Connecting up the terminal strip
USB interface settings for commissioning with STARTER.
Slave-to-slave communication via PROFIBUS DP
Acyclic communication via PROFIBUS DP (data set 47)
Connection of the converter to CANopen
Function overview
Frequency inverters with Control Units CU230P-2 HVAC, CU230P-2 DP, CU230P-2 CAN
Operating Instructions, 01/2011, FW 4.4, A5E02430659B AD
In Chapter
Installing Control Unit (Page 44)
•
Inverter control (Page 185)
•
Application-specific functions
•
(Page 219)
Braking functions of the converter
•
(Page 225)
Automatic restart and flying restart
•
(Page 237)
Commissioning with STARTER
•
(Page 68)
In Chapter
Installing Power Module (Page 30)
•
Technical data, Power Modules
•
(Page 305)
Installing Control Unit (Page 44)
•
Adapting the terminal strip
•
(Page 85)
Commissioning with STARTER
•
(Page 68)
• Communication via PROFIBUS
(Page 98)
Application examples (Page 323)
•
Acyclic communication (Page 113)
•
Application examples (Page 323)
•
Configuring the fieldbus (Page 97)
•
Functions (Page 183)
•
3