Refilling The Pot With Abrasive; Shutting Down - Graco EcoQuip2 EQm Operation, Repair, And Parts

Operation
Refilling the the Pot Pot with
Refilling Refilling the Pot
1. Close the abrasive ball valve (M).
2. Turn the selector valve to OFF.
3. Open the pot dump valve (J) to drain water from
the pot.
NOTE: NOTE: Be prepared to capture the water that NOTE:
will be drained from the pot. All disposals must
comply with national, state, and local regulations.
20
with Abrasive Abrasive
with Abrasive
4. Engage the pop-up pin by compressing the
spring and turning the handle 90° to hold the
pop-up in the open position.
5. Add the abrasive (see
Technical Specifications, page 66
information) and continue to step 8 from
Setting Up the Equipment, page

Shutting Down

Down
Shutting Shutting Down
1. When you have finished blasting, perform wash
until all of the abrasive is flushed from the blast
hose. See Using the Wash Feature, page
2. Turn the selector valve to OFF, and with the
abrasive ball valve closed, continue to blast until
water is cleared from the hose. This is to dry the
inside of the hose for storage.
3. Perform Pressure Relief Procedure, page
for capacity
13.
19.
10.
3A3489A