Setting Up The Equipment - Graco EcoQuip2 EQm Operation, Repair, And Parts

Setting Up Up the the Equipment Equipment
Setting Setting Up the Equipment
1. Fill the water tank with fresh water only, then
open the inlet ball valve (N).
2. Close the rinse ball valve (X) and abrasive ball
valve (M). Close the water dose meter (S) if
equipped.
3A3489A
3. Turn the selector valve to OFF.
4. Disengage the emergency stop (Q).
NOTE: The water pump will not work unless the
NOTE: NOTE:
Emergency Stop is disengaged.
5. Align the pop-up handle with the pin slot, and
then firmly push and turn the handle 90° after the
pin is below the bracket slot. Proper engagement
of the pin will hold the pop-up down until it is
released.
Operation
13