Product Overview
HTX 2030 with Base Coat Pump
(257369)
The HTX 2030 Sprayer comes equipped with a Base
Coat Pump 24B321. Only water-based materials are to
be used with this configuration, such as:
•
Smooth to heavily aggregated textures with silica
sand, perlite, vermiculite and polystyrene
•
Smooth, medium, coarse and extra coarse textures
•
Most materials with aggregates up to 2.5 mm (.100
in.) in longest dimension
When Base Coat Pump is Installed
Pump will only run when on/off switch is in ON position
AND:
•
Pump control is rotated clockwise away from OFF
position, and either of the following switches are
also switched ON:
Prime Switch on pressure control box AND/OR
Applicator Switch near end of material hose
The pressure control will limit the sprayer to 1,000 psi
(69 bar), stopping the pump whenever pressure limit is
reached.
313888F
Flow rate is dependent on engine speed and the setting
of the pump control knob.
1. Flow 3 (fully clockwise) - allows the pump to run
2. Flow 2 (near middle of the rotation) reduces flow
3. Flow 1 (near counterclockwise end of pump control)
ti13632a
4. OFF (fully counterclockwise) - stops pump com-
5. Adjust engine speed to control flow rate of sprayer.
continuously with minimal pulsation:
ti13756a
slightly by briefly interrupting pump:
ti13757a
reduces flow more by interrupting pump longer:
ti13758a
pletely:
ti13755a
Start with the slowest speed possible for maximum
spray control. Different spray tip nozzle sizes can
also be tried.
ti5251a
Product Overview
June 2019