Paper Size - Xerox DocuPrint 180 Product Manual

PRODUCT DIFFERENCES/USER CONSIDERATIONS

Paper size

Variable paper size
5-22
Figure 5-4 illustrates the portrait orientation shift and skew.
Figure 5-4. Portrait orientation shift and skew (8.5- by 11-
inches)
The following sections describe paper sizes.
Page dimensions up to the physical capacity of the feeder trays may
be selected. (The largest feeder tray physical capacity is 14 by 17
inch; the smallest is 7 by 10 inch with the optional Paper Feeding
Enhancement Kit installed). At system generation (sysgen), you can
select USLETTER, USLEGAL, or A4; or you can select "other" and
specify any paper size between the smallest and largest allowed (x
by y) in millimeters. 11- by 17-inch/297- by 432-mm jobs are not
supported, however, your Xerox DocuPrint 180 LPS handles 11- by
17-inch/297- by 432-mm IMG jobs.
The use of the PAPERSIZE command in PDL and the PAPER
command in FDL permits form compilation and job printing on a size
of paper other than the sysgened paper size and allows the
specification of nonstandard paper sizes for those jobs requiring
nonstandard paper
It is recommended that you sysgen to the largest size paper that you
commonly use. Smaller and less-used paper sizes should be
specified using PDL and FDL commands.
Refer to Xerox DocuPrint 180 LPS PDL Reference and Xerox
DocuPrint 180 LPS Forms Creation Guide for more information on
commands.
XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE