Using Your Xerox Docuprint 180 Lps As A Backup Lps - Xerox DocuPrint 180 Product Manual

Using your Xerox DocuPrint 180 LPS as a backup LPS

XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE
PRODUCT DIFFERENCES/USER CONSIDERATIONS
Tables 5-1 through 5-6 identify particular job features to consider
when printing a job on your Xerox DocuPrint 180 LPS which was
created on another Xerox LPS running a different software version.
Each table contains specific job features which may be encountered,
the projected results when printed on your Xerox DocuPrint 180 LPS,
and where to find further information.
Table 5-1. Will this 4635 (V3A R1.7) job print on my Xerox
DocuPrint 180 LPS
Job features from 4635
(V3A2 R1.7)
Programmable bypass
transport
Clusters
Edgemarking
Fonts
Graphics
Labels
Page density
Paper sizes
Paper stock
Stitch commands
Transparencies
MICR
Bar Code
Interpress
XNS
Ethernet
Results when run on DP 180 LPS
Job prints if DP 180 LPS has a bypass
transport and the finishing device is
required by the job. Otherwise, it does
not run.
Job prints. Operator needs to redefine
clusters if trays differ.
Job prints
Job prints if the fonts and character sets
used are loaded on the DocuPrint 180
LPS or if substi-tutions for these fonts
are defined.
Job prints if sufficient graphic memory is
available.
Job prints using only paper labels. Refer
to the Xerox DP 180 LPS Operator
Guide for loading instructions.
Job prints.
Job prints.
Job prints if it does not use edge
reinforced 3-hole stock.
No stitcher available on DP 180 LPS,
therefore stitch commands are ignored
and job prints unstitched.
Job prints.
A message will appear stating that the
system is not configured for this feature.
A message will appear stating that the
system is not configured for this feature.
A message will appear stating that the
system is not configured for this feature.
A message will appear stating that the
system is not configured for this feature.
A message will appear stating that the
system is not configured for this feature.
5-3