Remote Control Panel And Status Monitor Messages - Xerox DocuPrint 4508 User Manual

Table 6.2 RCP and SM messages (continued)
Message
I/O ERROR
MEMORY FULL
OFF-LINE
ON-LINE
R e m o t e C o n t r o l P a n e l a n d S t a t u s M o n i t o r M e s s a g e s
Condition/Problem
The printer's parallel cable does not
support bi-directional communication.
The communication between the
printer and PC/host is having problems.
The printer is not connected properly.
The printer received excessive data from
the computer to process and is out of
available memory.
You may have tried to transfer too
many soft fonts, or graphic image may
be too complex.
The status of the printer is OFF-LINE.
Printer is ready to receive data via the
parallel port.
Corrective Action
Check that the ports on your PC/host
are functioning and are not labeled
incorrectly.
Check the cable from your printer. It
could be loose or damaged.
Verify the connection from the printer
to the PC/host.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
Add additional printer memory SIMM.
Decrease page image complexity.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
Press the Front Panel key to place the
printer in ON-LINE state.
If the printer does not go to ON-LINE
state, unplug it from the wall outlet.
Wait one minute, then reconnect.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
No corrective action required.
C h a p t e r 6 : T r o u b l e s h o o t i n g
Table 6.2 Page 2 of 4
6-5