Ethertalk (Appletalk) Configuration; To Access Ethertalk Settings At The Device - Xerox WorkCentre 7335 System Administrator Manual

EtherTalk (AppleTalk) Configuration

The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk)
network.

To access EtherTalk Settings at the Device

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Port Settings.
8. Press the EtherTalk selection line on the Port Settings menu.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the horizontal
line selection, to access available settings press the Change Settings button in the lower right corner of
the touch screen.
42