Port Status (Snmp Enablement); Exiting The Snmp Selection Menu; Exiting The Port Settings Menu And Returning To The Device's Tools Tab Screen - Xerox WorkCentre 7335 System Administrator Manual

Port Status (SNMP Enablement)

1. On the SNMP selection menu, press the selection line labeled Port Status.
2. Press the Change Settings button.
3. On the Port Status screen, note which of the two buttons is highlighted as the current setting for SNMP
Enablement. The available settings are Enabled or Disabled. For SNMP to function, it must be set to
Enabled.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.

Exiting the SNMP Selection Menu

To exit the SNMP selection menu, which returns you to the Port Settings menu, press the rectangular
Close button in the upper right corner of the touch screen.

Exiting the Port Settings Menu and returning to the Device's Tools tab screen

6. To exit the Port Settings menu, returning to the Tools tab screen, press the rectangular Close button in
the upper right corner of the Port Settings menu screen.
7. Wait several seconds and the Auto Clear service should log you out.
Note: If you changed any settings in the Port Settings menu, the Device will automatically reboot to
register and enable your new settings.
15