Tcp/Ip Lpd Enablement; To Access Lpd Settings At The Device - Xerox WorkCentre 7335 System Administrator Manual

TCP/IP LPD Enablement

To support TCP/IP printing through the workstation's LPR port in the case of Windows XP, the LPD (Line
Printer Daemon) MUST be enabled at the device.
To view or change the Device's LPD setting, perform the following steps:

To access LPD Settings at the Device

1. Press the rectangular Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Port Settings.
8. When the Port Settings menu displays, press the selection line labeled LPD.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the LPD selections menu displays, note that you have a choice of setting selections by
numbered horizontal lines, with the current status of each setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the selection, to
access available settings press the Change Settings button in the lower right corner of the touch
screen.
29