System Trouble Diagnosis Through System Error Codes - Delta DVP-15MC Series Operation Manual

12.3 System Trouble Diagnosis through System Error
Codes
When the ERR indicator of DVP-15MC series motion controller blinks or is always ON, users can get to
know the cause of an error and shoot the trouble through selecting menu Device > Diagnosis
Information... in the CANopen Builder software of version 6.0 or above.
System error code
Hexadecimal Decimal
1000 4096
1001 4097
1002 4098
1003 4099
1004 4100
1005 4101
1007 4103
1008 4104
1009 4105
100A 4106
100B 4107
100C 4108
100D 4109
100E 4110
100F 4111
1010 4112
1011 4113
1012 4114
1013 4115
1014 4116
1015 4117
1016 4118
1017 4119
1018 4120
1019 4121
Explanation
Internal RAM detection failed
Internal Flash detection failed
The extension port detection
failed
Internal voltage is abnormal (LV)
Flash initializing failed
Flash ID detection failed.
The access to flash failed in the
Ethernet area.
The access to flash failed in the
extension area.
The access to flash failed in the
program area.
The access to flash failed in the
motion area.
The access to flash failed in the
Task area.
The access to flash failed in the
CANopen communication.
The access to flash failed in the
hardware configuration.
The access to flash failed in the
CAM area.
The access to flash (the flash
management table) failed.
The access to flash (sheet 1 in
the flash management table)
failed.
The access to flash (sheet 2 in
the flash management table) fails.
The reading of flash failed.
The writing in flash failed.
The erasing of the content in flash
failed.
CNC file ID is out of the allowed
range
The size of CNC file exceeds the
range
The position of incremental
encoder 1 changes dramatically in
short time.
The position of incremental
encoder 2 changes dramatically in
short time.
System stack is used up.
Chapter 12 Troubleshooting
Correction
Contact local technicians if the error still exists
after repower on.
Adjust input voltage to 24V at the power port.
Contact local technicians if the error still exists
after repower on.
Contact local technicians if the problem still
exists after re-downloading the program and
restoring the setting to the factory setting.
Check if the CNC file ID is larger than 64.
Update the software and redownload the
program if the error still exists after
redownloading the program.
CNC file is too large in size. Diminish the size
and redownload the program.
Check if the input of the encoder is too fast or
enlarge the resolution of the encoder.
Check if the input of the encoder is too fast or
enlarge the resolution of the encoder.
There are too many intermediate variables in
the program. Modify the program.
12
12-19