Agilent Technologies 1290 Infinity User Manual page 29

1 Ensure the power switch on the front of the autosampler is OFF and the
2 Connect the cable between the autosampler and the thermostat, see
3 Move the safety lever at the rear of the two modules to the right position,
4 Connect the power cables to the power connectors.
5 Connect the CAN interface cables to other modules in the system (see
6 If required, connect additional interface and control cables to the
In an Agilent 1290 Infinity system, the individual modules are connected by a CAN cable.
N O T E
The Agilent 1200 Infinity Series Instant Pilot can be connected to the CAN bus at any of the
modules in the system. The control software can be connected to the system by one GPIB
cable at any of the modules. If an Agilent detector is part of the system, the LAN
connection must be at the detector. For more information about connecting the instant pilot
or control software refer to the respective user manual. For connecting the Agilent 1290
Infinity equipment to non-Agilent 1290 Infinity equipment, see Autosampler manual).
1290 Infinity Thermostat User Manual
power cables are disconnected.
Figure 10 on page 30.
see Figure 10 on page 30.
Figure 5 on page 24 and
autosampler (see Figure 5
the documentation of the Agilent 1200 Infinity Series Instant Pilot or
ChemStation for LC for more information.
Installing the G1330B Thermostat
Installing the G1330B Thermostat
Figure 11 on page 31).
on page 24 and Figure 11 on page 31). Refer to
3
29