Siemens SIMATIC S7-1500 System Manual page 295

Parameter
● Tag of a STEP 7 code block:
● Tag for setting the behavior of a module (one or more per module). In as-delivered state,
every module has an appropriate basic setting, which you can change by configuring in
STEP 7. There are static and dynamic parameters
Parameters, dynamic
In contrast to static parameters, you can change dynamic parameters of modules during
operation by calling an SFC in the user program, e.g. limit values of an analog input module.
Parameters, static
In contrast to dynamic parameters, you cannot change static parameters of modules with the
user program but only by configuring in STEP 7, e.g. input delay of a digital input module.
PELV
Protective Extra Low Voltage = grounded extra low voltage with safe isolation
PLCopen
With these standardized instructions, you can use OPC UA client functions executed in an
S7-1500 CPU in your user program.
Pre-wiring
Wiring of the electrical system on the front connector before the front connector is used on
the I/O module.
Process image (I/O)
The CPU transfers the values from the input and output modules to this memory area. At the
start of the cyclic program the signal states of the input modules are transmitted to the
process image of the inputs. At the end of the cyclic program the process image of the
outputs is transmitted as signal state to the output modules.
Product version (PV) = Function version (FV)
The product version or function version provides information on the hardware version of the
module.
294
SIMATIC Drive Controller
System Manual, 11/2019, A5E46600094-AA