Table 3-2. Lbc-4000 Command Function Menus - Comtech EF Data LBC-4000 Installation And Operation Manual

L-Band Up/Down Converter System
System Operation

Table 3-2. LBC-4000 Command Function Menus

Level 1
LBC-4000
Ver: 1.1.2 SN: XXXXXXXXX
SELECT: Config Monitor Configure: Conv-A Conv-B
Faults Util Remote Redund RefAdj
Configure: Conv-A Conv-B
Remote Redund RefAdj
Configure: Conv-A Conv-B
Remote Redund RefAdj
Configure: Conv-A Conv-B
Remote Redund RefAdj
Configure: Conv-A Conv-B
Remote Redund RefAdj
SELECT: Config Monitor MONITOR: CONV-A CONV-B
Faults Util PwrSupA PwrSUpB RefOsc
SELECT: Config Monitor FAULTS:CONV-A CONV-B
Faults Util PwrSupA PwrSupB Stored
Level 2
CONFIG CnvX (IF=YYYMHZ)
Freq/Mute Attn/Slope
Where: YYY = 70 or 140 MHz
CONFIG CnvX (IF=YYYMHZ)
Freq/Mute Attn/Slope
Where: YYY = 70 or 140 MHz
CONFIG Remote: Control Mode
Address Interface Baud
CONFIG Redundancy:
Mode State FrcBkup
UTIL Ref-OSC:
Adjust=087 (L R U D E N T)
MON-A: iLO=04.1 rLO=14.6
Pi=+00.4 Po=+00.4 Tp=+32
MON-B: iLO=04.1 rLO=01.5
Pi=003 Po=+00.3 Tp=+30
MON Power SupplyA:
12V=12.3 8V=08.2 5V=05.3
MON Power SupplyB:
12V=12.2 8V=08.3 5V=05.3
MON Ref Osc: Vtune=04.7
FAULTS:CNV-A
IfLO=OK rfLO=OK temp=OK
FAULTS:CNV-B
IfLO=OK rfLO=OK temp=OK
FAULTS:Pwr Supply A:
12VT=OK 08VT=OK 05VT=OK
FAULTS:Pwr Supply B:
12VT=OK 08VT=OK 05VT=OK
FAULTS: Stored
View Clear
3-5
Level 3
CONFIG CnvA:
Frq=01980.000MHz Rx=On
CONFIG CnvA: Ofst=+0.0dB
Atten=00.00dB Slope=0.0
CONFIG CnvB:
Frq=00970.000MHz Rx=On
CONFIG CnvB: Ofst=+0.0dB
Atten=00.00dB Slope=0.0
CONFIG Remote:
Control Mode=Local
CONFIG Remote:
Unit Address=0001
CONFIG Remote:
Interface=RS-485
CONFIG Baud Params:
Rate=9600 Format=8N1
CONFIG Redundancy:
Control Mode=Manual
CONFIG Redundancy:
Control State=Enable
CONFIG Manual Redund:
Force Backup NO
Fault No. 01 10:28:53
OK-IFLO_A 08/10/04
Clear all stored
Faults? NO
MN/LBC4000.IOM
Revision 2
Level 4