Comtech EF Data LBC-4000 Installation And Operation Manual page 53

LBC-4000 L-Band Up/Down Converter System
Remote Control
Command
Parameter (Instruction
Type Code and
qualifier)
Retrieve N/A
Firmware
Number
Force Backup FBU_
Unit
Online Unit N/A
Status
Redundancy RED_
Mode
Set Auto/Manual SAM_
Redundancy
Mode
Arguments for
Description of arguments
Command or
(Note that all arguments are ASCII numeric
Response to
codes, that is, ASCII codes between 48 and 57)
Query
Query only
Gets the Firmware Numbers of the unit.
Example: FRW_
BULK=FW10023
M&C =FW11220
FPGA=FW11122
0 bytes Command only.
Forces switchover to backup unit in Manual
redundancy mode only.
Syntax:
FBU_
1 byte Query only.
alphanumeric Indicates which slot is online
Syntax:
ONL_x
where:
x = A or B (depending on which Converter is
online).
3 bytes Command and Query.
alphanumeric Used to set the chassis in redundancy mode or to
query status of redundancy.
Syntax:
RED_xxx
where:
xxx = ON, if redundancy is enabled
OFF, if redundancy is disabled
1 byte Command and Query.
alphanumeric Used to set or get status of Redundancy to either
Manual or Automatic mode
Syntax:
SAM_x
where:
x = a, if chassis is in Automatic Redundancy mode
m, if chassis is in Manual Redundancy mode
MN/LBC4000.IOM
Revision 2
Response to
Command
(target to
controller)
N/A
Same as command
N/A
Same as command
Same as command
A-13
Query Response to
(Instruction Query
Code and (target to
qualifier) controller)
FRW_ FRW_
(see description for
details of
arguments)
N/A N/A
ONL_ ONL_
(see description for
details of
arguments)
RED_ RED_
(see description for
details of
arguments)
SAM_ SAM_
(see description for
details of
arguments)