Fans - Trane Climate Changer T Series Installation Operation & Maintenance

Fans

Rotating Components!
Disconnect all electric power, including remote disconnects before servicing. Follow
proper lockout/ tagout procedures to ensure the equipment cannot be inadvertently
energized. Secure drive sheaves to ensure rotor cannot freewheel. Failure to secure
drive sheaves or disconnect power before servicing could result in death or serious
injury.
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow
proper lockout/tagout procedures to ensure the equipment cannot be inadvertently
energized. Failure to disconnect power before servicing could result in death or
serious injury.
Inspecting and Cleaning Fans
Fan sections of air handlers should be inspected every six months at a minimum or more
frequently if operating experience dictates. If evidence of microbial growth (mold) is
found, identify and remedy the cause immediately. Refer to the
section on page 66
1. Disconnect all electrical power to the unit.
2. Wearing the appropriate personal protective equipment, remove any contamination.
3. Vacuum the section with a vacuum device that uses high-efficiency particulate
4. Thoroughly clean any contaminated area(s) with a mild bleach and water solution or
5. Immediately rinse the affected surfaces thoroughly with fresh water and a fresh
6. Allow the unit to dry completely before putting it back into service.
7. Be careful any contaminated material does not contact other areas of the unit or
CLCH-SVX06A-EN • T-Series Climate Changer Air Handler IOM
WARNING
WARNING
for possible causes and solutions. To clean the fan section:
arrestance (HEPA) filters with a minimum efficiency of 99.97 percent at 0.3 micron
particle size.
an EPA-approved sanitizer specifically designed for HVAC use.
sponge to prevent potential corrosion of metal surfaces.
building. Properly dispose of all contaminated materials and cleaning solution.
Routine Maintenance
"Troubleshooting"
89