Trane Climate Changer T Series Installation Operation & Maintenance page 70

Installation - Electrical
To provide field-wiring to units with DDC or low limit controls:
•
•
•
Figure 56. Valve jack wiring details
Quick Connects
The actuators, factory-mounted or field-supplied, are separately wired and controlled by
a direct-digital controller or other building logic.
connect scheme.
Figure 57. Typical quick connects with wiring identification
Wire from
homerun cable
70
If VFD or starter is not factory-mounted, provide 120 Vac power to a transformer in
the valve jack when a separate circuit is recommended (see
Install outside-air sensor and space sensor, if ordered.
For valve jack mounting and wiring detail, see
Signal to
slave actuator
Conduit
assembly
Valve quick
connect
Figure 57
Power 24 Vac
Sig. 0-10 Vdc
T-Series Climate Changer Air Handler IOM • CLCH-SVX06A-EN
Figure 54).
Figure 56.
illustrates the typical quick
Actuator