Table of Contents
Advertisement
LA Selection and Logical Address
© National Instruments Corporation
Figure 6-8. VXI/VME-MXI-2 Configuration Editor
You can set or modify the logical address of the VXI/VME-MXI-2 either
within the VXI/VME-MXI-2 Configuration Editor itself or with the
onboard 8-position DIP switch. To select the configuration method you
prefer, use the LA Selection controls.
The default selection is the Switch option. Notice that the Logical Address
control is inaccessible, because it would have no effect. In this option you
need to change the hardware switch setting on the VXI/VME-MXI-2 itself
if you want to change the logical address.
If you select Software for this option, you can then use the Logical
Address control to select a logical address within the range of 1 to 254.
If you use this option, the hardware switch setting has no effect and you
must use the VXI/VME-MXI-2 Configuration Editor to change the logical
address.
Chapter 6
6-19
NI-VXI Configuration Utility
PCI-MXI-2 for Linux
Advertisement
Table of Contents
