Table of Contents
Advertisement
© National Instruments Corporation
4.
Replace the computer cover.
5.
Turn on the computer. The computer should boot this time because the
factory-default configuration is being used to initialize the PCI-MXI-2
module.
6.
Run
to re-adjust the PCI-MXI-2 configuration. Refer to
vxiedit
Chapter 6,
NI-VXI Configuration
utility.
7.
After saving the configuration, reboot the computer.
8.
Remove the top cover or access port to the PCI bus.
9.
Change switch 1 (FOV) on U17 (SW1 on the PCI-MXI-2 Universal)
to the OFF position.
10. Replace the computer cover.
11. Turn on the computer. If the computer does not boot with this
configuration, you will have to repeat these steps, modifying your
configuration until a final configuration is reached.
Appendix B
Utility, for instructions on using this
B-3
EEPROM Configuration
PCI-MXI-2 for Linux
Advertisement
Table of Contents
