Table of Contents
Advertisement
Default Settings
PCI-MXI-2
© National Instruments Corporation
The same functionality is available in
command. You can use
description.
You may now want to read the configuration registers from other VXI
devices in your system using the same procedure. The
accesses only the upper 16 KB of A16 space. Try reading the registers from
one of the devices listed in the Resource Manager Display of
In this way, you can verify that your PCI-MXI-2 can access each device in
your VXI system successfully.
You can also access VXI and VME defines that are configured in A16, A24,
and A32 address spaces by using the
or
commands in
vxiin
vxiout
This section summarizes the hardware and software default settings for the
PCI-MXI-2 kit. If you need more information about a particular setting, or
if you want to try a different configuration, please refer to the appropriate
hardware or software chapters in this manual. The manual flowchart at the
beginning of this chapter directs you to where to find the information
you need.
This section summarizes the hardware and software default settings for the
PCI-MXI-2.
Table 1-1. PCI-MXI-2 Hardware Default Settings
Hardware Component
U17 Switch 1 (FOV)
U17 Switch 2 (TST)
U17 Switch 3 (POS)
U17 Switch 4 (CT)
DRAM SIMM Installed
Chapter 1
victext
for the command's parameter
help vxiinreg
and
In
.
victext
OFF: PCI-MXI-2 boots off the
user-configured half of the EEPROM.
OFF: Factory configuration of the
EEPROM is protected.
OFF: Do not alter this setting.
ON: Do not alter this setting.
Per customer order
1-9
Introduction and Quick Start
with the
vxiinreg
operation
InReg
vxiedit
operations in
Out
vic
Default Setting
PCI-MXI-2 for Linux
.
or the
Advertisement
Table of Contents
