Table of Contents
Advertisement
VME-MXI-2 Configuration
and Installation
Electrostatic discharge can damage several components on your VME-MXI-2
Caution
module. To avoid such damage in handling the module, touch the antistatic plastic package
to a metal part of your VMEbus chassis before removing the VME-MXI-2 from the
package.
Configure the VME-MXI-2
© National Instruments Corporation
This chapter contains the instructions to configure and install the
VME-MXI-2 module. This chapter applies only if you ordered the
VME MXI-2 kit. If you ordered the VXI MXI-2 kit, you should refer
to Chapter 3,
VXI-MXI-2 Configuration and
This section describes how to configure the following options on the
VME-MXI-2:
•
VMEbus A16 base address
•
VME-MXI-2 intermodule signaling
•
MXIbus termination
•
Configuration EEPROM
•
Onboard DRAM
The VME-MXI-2 automatically detects if it is located in the first slot of
the chassis to perform the VMEbus System Controller functions. It is not
necessary to configure the VME-MXI-2 System Controller option. The
module can be installed in any slot of a VMEbus chassis.
Figure 4-1 shows the VME-MXI-2. The drawing shows the location and
factory-default settings of the configuration switches and jumpers on the
module.
4-1
4
Installation.
PCI-MXI-2 for Linux
Advertisement
Table of Contents
