Daikin VRV REYQ96MTJU Design, Installation & Testing Instruction page 205

Si39-406
13.Display "
14.Timer mode start/stop button
15.Timer on/off button
16.Inspection/test operation button
17.Programming time button
18.Temperature setting button
19.Filter sign reset button
20.Fan speed control button
21.Operation mode selector button
22.Air flow direction adjust button
23.Fan only/air conditioning selector switch
24.Cool/heat changeover switch
Note:
Operation Manual
Remote Controller and Changeover Switch: Name and Function of Each Switch and Display
" (defrost/hot start)
Refer to the chapter "Operation procedure - Explanation of heating operation."
Refer to the chapter "Operation procedure - Programming start and stop of the system with
timer."
Refer to the chapter "Operation procedure - Programming start and stop of the system with
timer."
This button is only used by qualified service persons for maintenance purposes.
Use this button for programming start and/or stop time.
Use this button for setting the desired temperature.
Refer to the indoor unit manual.
Press this button to select the fan speed of your preference.
Press this button to select the operation mode of your preference.
Refer to the chapter "Operation procedure - Adjusting the air flow direction".
Set the switch to " " for fan only operation or to "
Set the switch to " " for cooling or to "
In contradistinction to actual operating situations, the display on figure 2 shows all possible
indications.
If the filter sign lamp lights up, clean the air filter as explained in the indoor unit manual. After
cleaning and reinstalling the air filter, press the filter sign reset button on the remote controller.
The filter sign lamp on the display will go out.
" for heating or cooling operation.
" for heating operation.
199