Additional Functions - Bosch MUC6 Series Instruction Manual

Warning!
Condensation is formed during cooking.
Empty the condensation tank regularly.
Notes:
■ The preparation programme can be
stopped at any time using button H.
The appliance subsequently switches to
function selection mode.
■ Certain preparation programmes can
consist of several preparation steps.
X "Multiple preparation steps" see
page 15

Additional functions

The following additional functions are avail-
able for preparation programmes with and
without steam pressure function.
Selecting a pre-configured
preparation time
The pre-configured preparation time of
the level [ средняя ] (medium) is shown
on the control panel for each preparation
programme.
The preparation time can be shortened
[ короткая ] or lengthened [ длинная ].
1. Keep pressing button E until the
desired indicator is lit. The display
changes from [ средняя ] (medium)
to [ длинная ] (longer) and then to
[ короткая ] (shorter) before returning to
[ средняя ] (medium).
The corresponding pre-configured values
for the preparation time are shown in the
display.
2. Press button G to start the preparation
programme.
Setting a start time delay
The start time delay can be set for the
selected preparation programme so you
can enjoy a freshly prepared meal at a
specific time.
Note: the start time delay can only be
set for certain preparation programmes.
The pre-configured start time delay varies
among these preparation programmes.
MUC6-8_RU_8001018000.indb 15
Additional functions
1. Select the preparation programme.
2. Press button A. Button G flashes.
"00:10" flashes in the display.
Press button A repeatedly to increase the
displayed time. A brief press increases the
time by 5 minutes. A slightly longer press
increases the time by 10 minutes. Pressing
and holding button A for around 2 seconds
increases the time by 30 minutes.
3. Press button G when the desired start
time delay is displayed.
The desired start time delay is shown in the
display. [ таймер ] (timer) lights up in the
display.
The time until the start counts down. Once
this time has elapsed, the preparation
process starts automatically.
Notes:
■ The start time delay can be switched
off at any time by pressing button G.
The preparation programme then starts
immediately.
■ If "00:10" does not flash in the display,
a start time delay cannot be set for the
selected preparation programme.
Multiple preparation steps
Certain preparation programmes can
consist of several preparation steps. An
audible signal sounds once the next step is
required. In the control panel, LEDs 1, 2, 3
or 4 are shown accordingly and button G
flashes.
1. Open the lid of the appliance.
2. Add additional ingredients.
3. Depending on the recipe, refer to the
preparation method (e.g. with or without
steam pressure function, open lid).
X See recipe book provided
4. Start the next preparation step using
button G.
en
15
16.07.2015 12:15:08