1. Keep the steam release button pressed
until no more steam escapes from the
steam outlet.
2. Open the appliance. Open the pressure
locking handle for this purpose (M)
and press the opening button on the
basic appliance.
Note: If the pressure locking handle cannot
be opened, the appliance is not completely
depressurised. In this case, manually
depress the overpressure protection using
a thin pin until no more steam escapes
from the appliance. Then open the pressure
locking handle (M) and press the opening
button on the basic appliance.
Additional functions
The following additional functions are
available for preparation programmes with
and without steam pressure function.
Selecting a pre-configured
preparation time
The pre-configured preparation time of the
level [ medium ] is shown on the control
panel for each preparation programme.
The preparation time can be shortened
[ short ] or lengthened [ long ].
Additional functions
1. Keep pressing button E until the
desired indicator is lit. The display
changes from [ medium ] to [ long ] and
then to [ short ] before returning to
[ medium ].
The corresponding pre-configured values
for the preparation time are shown in the
display.
2. Press button G to start the preparation
programme.
Setting a start time delay
The start time delay can be set for the
selected preparation programme so you
can enjoy a freshly prepared meal at a
specific time.
Note: The start time delay can only be
set for certain preparation programmes.
The pre-configured start time delay varies
among these preparation programmes.
1. Select the preparation programme.
2. Press button A. Button G flashes.
"00:10" flashes in the display.
Press button A repeatedly to increase the
displayed time. A brief press increases the
time by 5 minutes. A slightly longer press
increases the time by 10 minutes. Pressing
and holding button A for around 2 seconds
increases the time by 30 minutes.
3. Press button G when the desired start
time delay is displayed.
The desired start time delay is shown in the
display. [ timer ] lights up in the display.
The time until the start counts down. Once
this time has elapsed, the preparation
process starts automatically.
Notes:
■ The start time delay can be switched
off at any time by pressing button G.
The preparation programme then starts
immediately.
■ If "00:10" does not flash in the display,
a start time delay cannot be set for the
selected preparation programme.
en
17