Clearing The Cmos - Canon imagePASS-A2 Service Manual

S P
ERVICE ROCEDURES
13 Reassemble the imagePASS and verify its functionality (see
14 If you installed a new CPU and cleared the CMOS, configure the time and date in Setup.

Clearing the CMOS

You must clear the CMOS after installing a new motherboard, CPU, DIMM, or hard disk
drive to ensure compatibility between the new component and the previous settings stored in
the BIOS.
T CMOS
O CLEAR THE
When you handle electronic components, follow electrostatic discharge (ESD) precautions
(see page 10).
1 Remove the imagePASS from the copier (see
As part of this step, you must disconnect the power cable. Do not proceed until you have
done so.
2 Open the imagePASS (see
3 Remove the battery (see
4 Wait two minutes to allow the motherboard electrical components to fully discharge.
5 Reinstall the battery (see
6 Reassemble the imagePASS and verify its functionality (see
7 Reset date and time in Setup (see Configuration and Setup, which is part of the user
documentation set).
page 14).
page 15).
page 32).
page 32).
page 17).
page 17).
40