Overview - Nortel Meridian 1 Option 11C Manual

Page 10 of 100 PRI Implementation
Reference list

Overview

553-3011-310 Standard 13.00
Set the switches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Insert the NTAK09 into the main cabinet . . . . . . . . . . . . . . . . . . . . . . . . 25
Connect the cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
Install IP daughterboards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Software enable the DTI/PRI cards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Software enable the NTRB21 TMDI card . . . . . . . . . . . . . . . . . . . . . . . . 26
Software enable the NTAK09 card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
Program Basic PRI . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Prerequisites . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Program procedure . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
The following are the references in this section:
• Networking Features and Services (553-2901-301)
• Administration (553-3001-311)
• Option 11C and 11C Mini Technical Reference Guide (553-3011-100)
• Option 11C Planning and Installation (553-3021-210)
Digital trunks are now supported in both Main Option 11C cabinets and IP
Expansion cabinets. This increased capability is possible with the
introduction of IP daughterboards in expansion cabinets and 100baseT or F
connectivity with the Main cabinet.
This chapter provides the information required to install PRI on a Meridian 1
Option 11C system:
• hardware and software installation
• programming procedures for basic call service.
While either the hardware or software may be installed first, the PRI cannot
be enabled and tested until both are completed.
January 2002