Ricoh FAX2900L Service Manual page 98

BIT SWITCHES
G4 Communication Parameters
Compression mode
Resolution
Width and reduction
Transfer
Confidential
Other parameters
System Switch 01
No FUNCTION
0 PM call
0: Disabled 1: Enabled
1-7 Not used
System Switch 02
No FUNCTION
0 Memory file transfer
0: Disabled
1: Enabled
1-5 Not used
6 Memory read/write by RDS
Bit 7 6 Setting
7
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
MMR: MMR compression
MR: MR compression
MH: MH compression
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
24: Fine (200 x 400 dpi)
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction (tx only)
A3: A3 (11.7"), no reduction (tx only)
T: Transfer, - : Other
C: Confidential, - : Other
The following information is shown in 6-bit format. Bit 1 is the
first bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing
Bit 3 - Not used
Bit 4 - mm/inch conversion
Bit 5 - Engine type
Bit 6 - Resolution unit
This bit switch determines whether the machine
will send an Auto Service Call to the service
station when it is time for PM.
Do not change these settings.
1: All messages in the memory (including
confidential RX messages) are sent to the fax
number that is stored as the service station.
Always reset this bit to zero after transfer.
Cross-reference
Service station number: Function 13
Do not change these settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked
out, but the user can temporarily switch RDS on
to allow RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03 (see
below). Note that if an RDS operation takes
place, RDS will not switch off until this time limit
has expired.
(1,1): At any time, an RDS system can access
the machine.
4-18
21 May, 1999
0: Enabled, 1: Disabled
0: Enabled, 1: Disabled
0: Disabled, 1: Enabled
0: mm, 1: inch
0: mm, 1: inch
COMMENTS
COMMENTS