Ricoh FAX2900L Service Manual page 102

BIT SWITCHES
System Switch 0C - Not used (do not change any of these settings)
System Switch 0D - Not used (do not change any of these settings)
System Switch 0E - Not used (do not change any of these settings)
System Switch 0F
No FUNCTION
0 Country code for functional
to settings (Hex)
7
00: France
01: Germany 11: USA
02: UK
03: Italy
04: Austria
05: Belgium 15: South Africa
06: Denmark 16: Australia
07: Finland 17: New Zealand
08: Ireland
09: Norway 19: Malaysia
0A: Sweden 20: Turkey
0B: Swiss.
0C: Portugal
0D: Holland
0E: Spain
0F: Israel
System Switch 10
No FUNCTION
0 Threshold memory level for
to parallel memory transmission
7
System Switch 11
No FUNCTION
0 TTI printing position
0: Superimposed on the page
data
1: Printed before the data
leading edge
1 CIL printing position
0: Printed before the data
leading edge
1: Superimposed on the page
data
2-5 Not used
10: Not used
12: Asia
13: Not used
14: Hong Kong
18: Singapore
21: Greece
COMMENTS
This country code determines the factory
settings of bit switches and RAM addresses.
However, it has no effect on the NCU
parameter settings and communication
parameter RAM addresses.
Cross-reference
NCU country code: Function 08, parameter CC.
The bit switch country code will automatically
be changed to the same country code with the
NCU country code when you change the NCU
country code and exit the service mode.
NOTE:
If RAM reset level 1 is done, this bit
switch resets to 02 (UK).
COMMENTS
Threshold mount = N x 64 kbytes
N can be between 00 - FF(H)
Default setting: 04(H) = 256 kbytes
COMMENTS
Change this bit to 1 if the TTI overprints
information that the customer considers to be
important (G3 transmissions).
Change this bit to 1 if the CIL overprints
information that the customer considers to be
important (G4 transmissions).
Do not change these settings.
4-22
21 May, 1999