Frame Assembly - Weider 831.159530 User Manual

Frame Assembly

1. Before beginning, make sure that you have
read and understood the information on page 5.
Locate and open the parts bags labeled
"FRAME ASSEMBLY 1 and 2."
Press a 2" Square Inner Cap (59) into each end
of the Butterfly Base (1).
Insert four 5/16" x 2 1/2" Carriage Bolts (54) up
through the Butterfly Base (1). Place the Butterfly
Base flat on the floor. Note: If the Bolts fall out,
secure them with a small piece of tape.
Attach the Center Base (2) to the Butterfly Base
(1) with two 5/16" x 2 3/4" Bolts (55), a Long
Support Plate (34), and two 5/16" Nylon Locknuts
(64). Do not tighten the Nylon Locknuts yet.
2. Press a 2" Square Inner Cap (59) into each end
of the Press Base (3).
Insert four 5/16" x 2 1/2" Carriage Bolts (54) and
two 3/8" x 2 1/2" Carriage Bolts (76) up through
the Press Base (3). Place the Press Base flat on
the floor. Note: If the Bolts fall out, secure
them with a small piece of tape.
Attach the Press Base (3) to the Center Base (2)
with two 5/16" x 2 3/4" Bolts (55), a Long Support
Plate (34), and two 5/16" Nylon Locknuts (64). Do
not tighten the Nylon Locknuts yet.
3. Orient the Butterfly Upright (4) as shown. Attach
the Butterfly Upright to the indicated 5/16" x 2
1/2" Carriage Bolts (54) in the Butterfly Base (1)
with two 5/16" Nylon Locknuts (64). Do not tight-
en the Nylon Locknuts yet.
1
54
59
2
2
3
59
54
3
6
59
55
34
1
64
2
54
64
59
64
76
54
4
64
64
54
1
64
34
55