Frame Assembly; Weight Resistance Chart - Weider WEEVSY1975.0 User Manual

Frame Assembly

1.
Before beginning assembly, make sure you
understand the information in the box on
page 5. Refer to the PART IDENTIFICATION
CHART in the centre of this manual for help
identifying small parts.
Insert four M8 x 63mm Carriage Bolts (78) up
through the Base (1). Note: It may be helpful to
place a piece of tape over the bolt heads to
hold them in place.
2. Attach the Base (1) and the two Weight Guides
(21) to the Stabiliser (2) with two M10 x 67mm
Bolts (71), two M10 Washers (57), and two M10
Nylon Locknuts (56). Make sure the indicated
holes in the Weight Guides are nearer the bot-
tom. Fully tighten the Locknuts.
Attach the Upright (3) to the Base (1) with the
indicated two M8 x 63mm Carriage Bolts (78) and
two M8 Nylon Locknuts (58). Do not tighten the
Locknuts yet.
1
1
78
78
2
Holes
21
21
3
57
56
57
58 71
58
2
71
1
78
6

WEIGHT RESISTANCE CHART

The chart below shows the approximate weight resistance at each exercise station. "Top" refers to the 6 lb. top
weight. The other numbers refer to the 12.5 lb. weight plates. Weight resistance shown for the butterfly arm sta-
tion is for each arm. Note: The actual resistance at each station may vary due to differences in individual
weight plates as well as friction between the cables, pulleys, and weight guides.
WEIGHT HIGH BUTTERFLY
PULLEY ARM
(lbs.) (lbs.)
Top 11 16
1 26 22
2
42 30
3 61 41
4 70 51
5
86 63
6 101 82
PRESS ARM LEG LEVER LOW
(lbs.) (lbs.) PULLEY
(lbs.)
27 27 26
44 57 55
62 85 86
97 111 119
127 159 148
144 182 163
173 214 187
19