10-32
WLS 8400 Product Reference Guide
Setup Field(s)
Parameter
Move Cursor
Move Cursor To a Character
Move Cursor to Start of Data
Move Cursor Past a Character
Skip Ahead "N" Characters
Skip Back "N" Characters
Send Preset Value
Table 10-1. Setup Field(s) Definitions
Scan the
Move Cursor To Character bar code on page
, then any printable ASCII character from the
10-33
Alphanumeric
Keyboard. When this is used, the
cursor moves to the position after the matching
character. If the character is not there, the rule fails
and ADF tries the next rule.
Scan this bar code to move cursor to the beginning of the
data.
This parameter moves the cursor past all sequential
occurrences of a selected character. For example, if the
selected character is 'A', then the cursor moves past 'A',
'AA', 'AAA', etc. Scan the Move Cursor Past Character
bar code on page 10-33, then select a character from the
Alphanumeric
Keyboard. If the character is not there, the
cursor does not move (i.e., has no effect).
Scan one of these bar codes to select the desired number of
positions to move the cursor ahead.
Scan one of these bar codes to select the desired number of
positions to move the cursor back.
Send prefix and/or suffix value by scanning the appropriate
bar code. These values must be set using the Scan Prefix
and Scan Suffix bar codes on
Description
page
9-6.
Page
10-33
10-33
10-33
10-34
10-36
10-38